Fluke ScopeMeter® 190B Series Firmware Upgrade

A firmware upgrade for ScopeMeter test tool 190B Series is available, major changes are:

  • Remote Control improved (V7.06)
  • Zoom in 2s/div timebase setting improved and micro symbol added in readings symbol table (V7.04)
  • Improved screen update rate (V7.02)
  • Deeper waveform memory up to 3K spectrum analysis using Fast Fourier Transformation (V7.00)
  • Two new trigger modes (n-cycle and dual edge) (V7.00)
  • Cursor limited automatic measurement (rms Watt etc between cursors) (V7.00)

Upgrading Version V7.00, V7.01, V7.02 or V7.04 to Version V7.06 - Instruments with version V7.00 to V7.04 are field upgradable free of charge.

Please contact the Fluke service department for firmware updates on this product.

FlashTool Software requirements:

  • Fluke 190 B Series ScopeMeter or 190B Series (Monochrome) ScopeMeter, with firmware V7.00 - V7.04. (See Firmware Level Check above);
  • A PC, running Windows 95, 98, Me, 2000, NT 4.0, XP or Vista, with a free RS-232 or USB port to perform the software installation;
  • PM9080 or OC4USB (RevII) optically isolated serial interface cable (as included with the ScopeMeter 19x B /S model and with the SCC-190 kit) for data interconnection between the PC and the instrument

Upgrading earlier Versions - Instruments with firmware version V5.0x and V6.x cannot be upgraded to V7.06 in the field. These instruments require re-calibration after upgrading. Therefore these units must be returned to a Fluke Authorized Service Center. Contact your local service center and order a firmware upgrade and calibration according to PCN 4841. Note: For the firmware upgrade and calibration a nominal fee will be charged!

Please contact the Fluke service department for firmware updates on this product.

For Versions V6.00, V6.10, V6.11 and V6.12 to V6.13

GPL Offer