molbox2 and molbox2-S

This flash is intended ONLY for molbox2 or molbox2S with the Fluke Calibration logo: 


 

Not applicable for serial numbers 4000 and below.

Run Winflash and select the file downloaded as the file to write to the product.

Make sure the correct COM port of the product is connected to a RS232 port on the host PC. Use a null modem cable to COM2 port of PG7000 Piston Gauge. Use a Standard RS232 cable to COM1 port of molbox2 unit.

The updating of embedded software should only be performed after given specific instructions to do so from a Fluke Calibration Authorized Service Center.


If the update Isn’t performed properly, your product will be inoperable until it is updated correctly. Updates Include: v7.0.2.00 (Display Version 7.00b)
Corrects flow on Channel A, when two molbloc-L-2 flow ranges are installed on Channel A and Channel B in molbox2.