Middle East [Change]  |  Fluke [Change Company]
fluke
Home  |  Products  |  Digital Multimeters  |  
Contact usRefer this page

Fluke 27 II/28 II Industrial Multimeters

Contact Me
Request A Demo
 Fluke 27 II/28 II
The NEW standard for rugged

The Fluke 27 II and 28 II digital multimeters define a new standard for operating in harsh conditions with the features and accuracy to troubleshoot most electrical problems. Both meters have IP 67 (waterproof and dustproof) rating, MSHA approvals, extended operating temperature range of -15 °C to +55 °C (5 °F to 131 °F, -40 °C for up to 20 minutes) and 95 % humidity, and have been designed and tested to withstand a 3 m (10 ft) drop. The Fluke 20 Series Multimeters are built to work in the toughest environments.

  • Measure up to 1000 V ac and dc
  • Measure up to 10 A (20 A for 30 seconds)
  • 10,000 μF capacitance range
  • Frequency to 200 kHz
  • Extended ac voltage bandwidth– 15 Hz to 20 kHz (28 II), 40 Hz to 30 kHz (27 II)
  • Built in thermometer conveniently allows you to take temperature readings without having to carry a separate instrument (28 II)
  • Resistance, continuity and diode test
  • Min/Max and average recording to capture variations automatically
  • Peak min-max (28 II)
  • Unique function for accurate voltage and frequency measurements on adjustable speed motor drives and other electrically noisy equipment (28 II)

Features:

  • New – IP 67 waterproof & dustproof protection, completely sealed for use in harsh environments
  • Designed to withstand 3 meter drop (with holster)
  • Hi resolution 20,000 count display mode (28 II)
  • True-rms ac voltage and current for accurate measurements on non linear signals (28 II)
  • Average responding voltage and current for measurements (27 II)
  • New – Backlit keypad buttons allow for easy visibility in lowlit areas
  • Large display digits and 2 level bright white backlight for increased visibility
  • Reversible holster for added protection when not in use
  • Withstands hazardous 8,000 volt spikes caused by load switching and faults on industrial circuits and complies with second edition IEC and ANSI electrical safety standards
  • Long battery life (800 hours)
  • Relative mode to remove test lead resistance from low ohms measurements
  • Auto and manual ranging for maximum flexibility
  • Optional magnetic hanger for easy setup and viewing while freeing your hands for other tasks
  • MSHA approval
Accuracy specifications
DC voltage
Range  0.1 mV to 1000 V
Accuracy  27-II:0.1 % +1
28-II:0.05 % + 1
AC voltage
Range  0.1 mV to 1000 V
Accuracy  27-II: 0.5 % +3
28-II: 0.7 % +4
DC current
Range  0.1 μA to 10 A
Accuracy  27-II: 0.2 % + 4
28-II: 0.2 % + 4
AC current
Range  0.1 μA to 10 A
Accuracy  27-II: 1.5 % + 2
28-II: 1.0 % + 2
Resistance
Range  0.1 Ω to 50 MΩ
Display counts
27-II  6000
28-II  6000/19,999
Capacitance
 1 nF to 9999 μF
Frequency
 0.5 Hz to 199.99 kHz
Temperature
 27-II: N/A
28-II: -200 °C to +1090 °C
Low pass filter (Measurement on VSD’s)
 27-II: N/A
28-II: Yes
Compliance
 CAT IV 600 V , CAT III 1000V
IP rating
27-II:  IP 67
28-II:  IP 67
Power
 Three AA batteries
Battery life
 800 hours

General specifications
Display
Bar graph/backlight  Yes/Yes
Data storage
Peak transient capture  250 μS (28 II)
Min/Max/Avg  Yes
Reading hold  Yes
Other features
Relative readings (zero)  Yes
Battery type  Three AA batteries
Warranty and protection
Safety rating  CAT IV 600 V/CAT III 1000 V
External protection  Rubber holster
Drop test  10 feet drop test
Dustproof/waterproof  Yes, IP 67 rated
Warranty  Limited lifetime
Size (HxWxL) with holster  6.35 cm x 10.0 cm x 19.81 cm (2.5 in x 3.93 in x 7.8 in)
Weight with holster  698.5 g (1.54 lb)
Model NameDescriptionPrice List
FLUKE 27-IIIndustrial Multimeter On Request
FLUKE 28-IIIndustrial Multimeter On Request

ClipsPrice List
AC285AC285 SureGrip™ Alligator Clip SetOn Request
TLK225TLK225 SureGrip™ Master Accessory KitOn Request

Cases and HolstersPrice List
C100C100 Hard Meter and Accessory CaseOn Request
C101C101 Hard CaseOn Request
C125C125 Soft Meter Case On Request
C550C550 Tool BagOn Request
CXT80CXT80 Extreme CaseOn Request

Current clampsPrice List
i1010i1010 AC/DC Current ClampOn Request
i200i200 AC Current ClampOn Request
i2000 flexi2000 flex AC Current ClampOn Request
i3000si3000s AC Current ClampOn Request
i400i400 AC Current ClampOn Request
i410i410 AC/DC Current ClampOn Request

Fiber OpticsPrice List
FOM Fiber Optic Meter FOM Fiber Optic MeterOn Request

High Voltage ProbesPrice List
80k-1580K-15 High Voltage ProbeOn Request
80K-4080K-40 High Voltage ProbeOn Request
80K-680K-6 High Voltage ProbeOn Request

LightsPrice List
L206L206 Deluxe LED Hat LightOn Request
L210L210 Probe Light + Probe ExtenderOn Request
L215L215 SureGrip™ Kit with Probe Light and Probe ExtenderOn Request
LVD2LVD2 Volt LightOn Request

PressurePrice List
PV350PV350 Pressure Vacuum ModuleOn Request

TemperaturePrice List
80AK-A80AK-A Thermocouple AdapterOn Request
80PK-180PK-1 Bead Probe (Type K) On Request
80PK-2780PK-27 Industrial Surface ProbeOn Request
80PK-3A80PK-3A Surface Probe (Type K)On Request
80PK-880PK-8 Pipe Clamp Temperature Probe (Type K)On Request
80PK-980PK-9 General Purpose Probe (Type K)On Request
80PK-EXT80PK-EXT Extension Wire Kit (Type K)On Request
80T-150UA80T-150U Universal Temperature Probe (for DMMs)On Request
80TK80TK Thermocouple Module (Type K)On Request

Test LeadsPrice List
TL220TL220 SureGrip™ Industrial Test Lead KitOn Request
TL223TL223 SureGrip™ Electrical Test Lead KitOn Request
TL71TL71 Test Lead SetOn Request
Made in the USA      
Search Fluke
ResourcesProducts
Find Resources
Related Products
 
 TL175 TwistGuard™ Test Leads »
 
 TL224 SureGrip™ Silicone Test Lead Set »
 
 TPAK ToolPak, Meter Hanging Kit »

Home | Site Map | Fluke Corporation  | Terms and Conditions | Privacy Statement | Disclaimer© 1995 - 2013 Fluke Corporation