Significantly improve equipment performance, compliance, reliability, and lifespan
Fluke 810 Handheld Vibration Tester February 2012
- Conduct automated vibration analysis of mechanical equipment and pinpoint the location, the cause, and severity of the problem
- Identify bearing problems, misalignment, looseness, and unbalance
- Synchronize and view four different automation sequences with one oscilloscope
- Troubleshoot VFD and PLC digital signals and power parameters with power quality analyzers and oscilloscopes
- Trace faulty analog I/O signals by using a milliamp clamp to measure milliamp signals without breaking the loop
- Calibrate pressure and temperature sensors transmitters in the field
- Inspect steam pipes and traps with thermal imaging
- Conduct non-contact thermal inspection of conveyors to spot bearing, lubrication, and motor issues
- Measure and log highly accurate, repeatable temperatures with a non-mercury portable reference thermometer
- Accurately troubleshoot electrically noisy devices with filtered clamp meters and multimeters
- Spot-check electrical panels with thermal imaging and follow up with basic voltage and amperage measurements
 |
|
 |
|
Fluke 190 Series II ScopeMeter® Tool |
|
Fluke Ti10 Thermal Imager |
- Connect an electrical measurement tool at one point, remove the display, and walk up to 30 feet (9 meters) away to test a controls sequence
- Resolve intermittent equipment performance issues by logging signals over time to capture the specific event, usually a conflict between electronic and electrical systems
- Verify health, integrity of bus and network physical layer signals with ScopeMeter® bus health
- Improve output consistency from cooking and packaging application with thermal scanning
- Document field calibrations of signal tests with a portable recorder, either a documenting process calibrator or a handheld ScopeMeter® oscilloscope
- Resolve the root cause of motors or transformers that run hot with power quality analysis
 |
|
 |
|
Fluke 568 Infrared and Contact Thermometer |
|
Fluke 434 Power Quality Analyzer
(three-phase) | |